How to Match Glass Splashbacks for Kitchens

Fitting glass splashbacks is amazingly quick, so even if you are not brave enough to deal with measuring oneself you should really think about fitting your self, conserving you a whole lot of money on set up charges.

To get began fitting your possess glass splashbacks, you will need the following applications.

Silicone gun
Tile spacers
Neutral cure silicone
Builders wipes
Electrical screwdriver (optional)
If you need to have to in good shape around electrical sockets or plumbing fixings you have to initially take out any fittings. For electrical sockets ensure the electricity is completely isolated and examination this making use of a stage tester/socket tester. It is almost certainly most effective to get a competent Electrician to do this for you.

The greatest wall panel to start off on is usually your principal cooker splashback or centre wall panel. Place it with the painted facet up on a stage area. Open up your silicone and area it within your silicone gun. Give the partitions a fast dust and the rear of the glass so almost everything sticks correctly when fitted. Upcoming, making use of your silicone gun use blobs of silicone/adhesive evenly on the painted facet of the glass.

Carry the glass panel and position it firmly in opposition to the wall, preserve the enlargement gaps you left making use of 2mm tile spacers (so position them beneath the glass and around the edges). The up coming splashback or wall panel you need to in good shape need to be instantly beside your most important splashback. So again, position it deal with down and implement your adhesive to the rear of the panel, push to the wall and maintain your growth gaps using tile spacers. Don’t forget, no growth hole is important where a glass panel satisfies yet another panel, so guarantee the joints are limited and flush. If there is any silicone/adhesive on the glass wipe it off before it hardens applying your builders wipes. If you have any queries concerning exactly where and how to use cooker splashback 100cm, you can contact us at the internet site.

Repeat the earlier mentioned for your remaining splashbacks and refit any plumbing fittings or electrical sockets. You should now leave the spacers in put for at minimum 24 several hours to allow the adhesive to established. To test it has set, remove the base spacers and endeavor to go the splashback, if you simply cannot then you are completely ready to seal your splashbacks.

Leave a Reply

Your email address will not be published. Required fields are marked *